Dell PowerEdge 1850 Handbuch Seite 3

Figure 2. Installing a RAC Card
RAC card connector
Enter the System Setup program and verify that the setting for the Boot Sequence has
15
changed to reflect the presence of the card. You should see options for virtual disk for
CDROM and LS-120. See "Using the System Setup Program" in your User's Guide.
When the system boots, the Remote Access Control Detected message displays and
the option ROM and firmware information for the RAC displays. Press <Ctrl><d> to enter
the configuration screen for the RAC.
See the RAC card documentation for information on configuring and using the RAC card.
___________
Information in this document is subject to change without notice.
© 2004 Dell Inc. All rights reserved. Printed in the U.S.A.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc. Other trademarks and trade names may be
used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any
proprietary interest in trademarks and trade names other than its own.
RAC card
NIC connector
standoffs (4)