HABYS Upright Chiro Z7 Bedienungsanleitung Seite 3

I. GENERAL SAFETY AND USE OF THE TABLE
1. Please read the instructions before using the product.
2. Before using, place the product on a flat surface.
3. Before use, make sure that the product does not wobble or tilt, and that all elements are
properly attached and tightened.
4. Do not use the product if any of the product components are malfunctioning or damaged.
5. Do not stand or jump on the product.
6. Do not put fingers or other parts of the body into the area of the regulation mechanisms.
7. Do not expose the product to strong sunlight.
8. Do not use the product in extreme temperature and humidity conditions.
9. Do not allow the product to be loaded with a pressure greater than the maximum specified in the
technical parameters, ie 200 [kg].
10. After bringing the table from a cold room, connect it to the mains after waiting 15 minutes.
11. It is recommended that the table be fully adjusted in height from minimum to maximum to
ensure even distribution of the lubricant inside the motor. This ensures proper table
maintenance and extends the engine life. The operation should be repeated 2 or 4 times min.
once a week.
12. Do not remove the plug from the socket by pulling the cord.
13. Use the product only in accordance with its intended purpose, in the event of use other than
that specified in this manual, there is a serious risk of injury, damage to health and damage to
the product.
14. Do not make any modifications or repairs to the product, do not disassemble the product.
15. In the event of finding any defects, immediately contact the manufacturer and do not use the
product until the defect is remedied.
16. No contraindications for the use of the product only after meeting the above recommendations.
17. Each serious incident related to the device should be reported to the manufacturer and the
Office for Registration of Medicinal Products, Medical Devices and Biocidal Products.
II. INTENDED USE OF THE PRODUCT
The Habys Upright Chiro Z7 stationary table is a professional table for chiropractic, manual techniques and
osteopathy. Thanks to a wide range of adjustments in various planes, segments for "drop" techniques and an
electric top lifting system, the table is a perfect complement to the therapist's work.
Due to its design solutions and functions, the product should be used by personnel qualified in the field of
manual therapy, chiropractic or osteopathy.
III. CLEANING AND MAINTENANCE
The metal structure of the table should be cleaned with a damp cloth and mild cleaning agents. The elements
of the upholstery should be cleaned with generally available agents intended for cleaning upholstery. Do not
use harsh chemicals and those based on alcohol.
IV. CONSTRUCTION AND TECHNICAL DATA
Product components:
1. Frame - strong and durable structure made of a steel bearing frame covered with a varnish coating.
2. Support elements - made of 40 [mm] integral foam.
3. Electric system for lifting the table top in the range of 55 - 97 [cm], adjustment by means of:
- central control frame;
- handheld remote (additional option).
2