Intex Built-in Fast-Fill AP620A Bedienungsanleitung Seite 3

INFLATION
1. Open line cord compartment cover. See Fig (1).
2. Plug in the AC line cord into an AC electrical outlet. See Fig (2).
FIG (1)
3. Turn the control dial clockwise until arrow points to the inflation mark (
4. Press "I" to switch ON. See Fig (4).
5. When the airbed is fully inflated to the desired firmness, press "O" to switch OFF. See
Fig (5).
6. Lie down on the airbed to test the firmness.
7. If the sleeping surface is too hard, adjust the firmness
by turning the control dial counterclockwise gradually
until air starts to exit through the air passage. See
Fig (6). Turn the control dial fully clockwise when the
desired firmness is achieved. See Fig (7). If the airbed
becomes too soft repeat step #3 thru #7 as necessary.
8. Disconnect the AC line cord from the wall socket,
place it inside the cord compartment and close the
cover.
Inflate only with a low pressure inflator. Do not over inflate. Fill with cold air only.
SAVE THESE INSTRUCTIONS
(152) AP620A BUILT-IN ELECTRIC PUMP ENGLISH 4.875" X 7.25" 06/26/2018
FIG (3)
IMPORTANT
Page 3
220 – 240 V
√
FIG (2)
FIG (4)
FIG (6)
English
152
110 – 120 V
). See Fig (3).
FIG (5)
FIG (7)