Remote Controller; Preparation Before Operation; Auto Restart Function; Indoor Unit - Mitsubishi Electric MCFZ-A12WV Bedienungsanleitung

NAME OF EACH PART

Remote controller

Signal transmitting section
Operation display section
ON/OFF (operate/
stop) button
Open the front lid.
(This diagram shows an overall view.)
Fan speed control button
HEAT
Operation select button
ECONO COOL
ECONO COOL button
RESET button
4
˚C
CLOCK
AMPM
12345
AMPM
TOO TOO
ON/OFF
WARM COOL
Temperature buttons
AMPM
12345
AMPM
TOO TOO
ON/OFF
WARM COOL
FAN STOP
I FEEL Off-timer button
AUTO
VANE START
On-timer button
DRY COOL
MODE HR.
HR.button
MIN.button
MIN.
(Time set buttons)
RESET CLOCK
CLOCK set button
Vane control button

PREPARATION BEFORE OPERATION

Auto restart function

I
These models are equipped with an auto restart function. If you do not want to use this function,
please consult the service representative because the setting of the unit needs to be changed.
Auto restart function is ...
When the indoor unit is controlled with the remote controller, the operation mode, the set temperature and the fan speed are
stored in the memory. If a power failure occurs or the main power is turned off during operation, "Auto restart function" sets
automatically to start operating in the same mode as the one set with the remote controller just before the shutoff of the main
power. (Refer to page 6 for details.)

Indoor unit

I
Insert the power supply plug into the power outlet and/or turn the breaker on.
WARNING:
Remove dirt from the power supply plug and insert the plug securely.
If dirt adheres to the plug or insertion is incomplete, it may cause a fire or an electric shock.