Hyperx Ngenuity Software; Battery Replacement - Hyperx Pulsefire Saga Pro Schnellstartanleitung

RGB Lighting Profiles
There are 4 default DPI presets: 400 DPI (Red) | 800 DPI (Blue) | 1600 DPI (Yellow) | 3200 DPI (Green). Max DPI: Up to 26000 DPI.

HyperX NGENUITY Software

To customize lighting, DPI, macro settings, and more, download HyperX NGENUITY software at hyperx.com/pages/ngenuity
Questions or Setup Issues?
Contact the HyperX support team at hyperx.com/support

Battery Replacement

1. Turn O the Mouse. Switch power mode to "OFF".
2. Remove the mouse skates with a at, plastic tool (e.g. spudger, ngernails) to reveal and unscrew the 4x Torx 6 Security screws below.
3. Remove the Shell and Button Cover to reveal and unscrew the 2x Philips screws at the top of the mouse. Separate the top piece from the mouse.
4. Gently separate and lift the top shell from the bottom shell, in an upward motion
5. Locate and remove the battery secured with a connector.
6. Place new battery matching correct pin orientation.
7. Close bottom and top case of the mouse. Reverse step 3 and 2.
8. Turn on the Mouse and test for functionality.