Charging; Dpi Presets; Hyperx Ngenuity Software; Factory Reset - HyperX Pulsefire Haste Wireless Anleitung

Charging

It is recommended to fully charge your mouse before first use. Battery percentage can be
found within NGENUITY.
The mouse is charged via USB-C, located at the top part of the mouse. While the cable is
attached, the mouse will operate in wired mode.

DPI Presets

There are 4 default DPI presets
400 DPI (red), 800 DPI (blue), 1600 DPI (yellow), 3200 DPI (green).
Up to 5 DPI presets can be stored on the mouse. Customizing and saving DPI settings can be
done with NGENUITY.

HyperX NGENUITY Software

To customize lighting, DPI, polling rate, lift off distance, macro settings, and check battery life,
download the HyperX NGENUITY software at: hyperxgaming.com/ngenuity.

Factory Reset

If you are experiencing any issues with the mouse, you can perform a factory reset. Onboard
memory will be cleared, and all settings will revert to default DPI settings listed above and
lighting effects (Rainbow Cycle).
Hold DPI button + mouse wheel button down for 5 seconds. The mouse wheel will flash red
momentarily and disappear once reset has completed.
Questions or Setup Issues?
Contact the HyperX support team at: hyperxgaming.com/support/
Document No. 4P5D#AA.A01 HyperX Pulsefire Haste Wireless Page 8 of 8