Bluetooth Pairing - Hyperx Pulsefire Saga Pro Schnellstartanleitung

ENGLISH
Overview
A - Left click button
B - Right click button
C - Mouse wheel
D - Forward button (1)
E - Back button (1)
F - USB-C port
G - HyperX 26K Sensor
H - Power mode switch
I - DPI Button
J - Shell (1)
K - Button cover (A)
Charging and Wired Mode
It is recommended to fully charge your mouse before rst use.
Connect the mouse to a PC or game console using the included USB cable. USB
connectivity will override the selected power mode.
Installation
2.4G Wireless Mode
1. Switch the mouse to 2.4G power mode.
2. Connect the USB 4k wireless dongle to the extension adapter.
3. Connect the extension adapter to a PC or game console using the included USB
cable.
Bluetooth Mode
1. Switch the mouse to Bluetooth power mode.
The mouse will ash blue on the rst setup.
2. Go to your computer's Bluetooth settings, search, and connect to "Saga Pro".

Bluetooth Pairing

Hold the left click button, right click button, and the DPI button simultaneously
until the mouse ashes blue.
Onboard Polling Rate Switch
The default polling rate is 1k polling rate.
Enable 4k Wireless Polling Rate
1. Power o the mouse completely.
2. Press and hold the DPI button. While holding the DPI button, switch the mouse
to 2.4G mode.
The wheel LED will fast-blink green four times.
To revert to the default 1k polling rate, follow the same procedure. The wheel LED
will fast-blink green two times.
Modular Parts
Includes 2 sets of magnetic, modular parts (shell, button cover, and side buttons)
L - USB wireless dongle storage
M - Button cover (B)
N - Forward button (2)
O - Back button (2)
P - Shell (2)
Q - Grip tape
R - Spare mouse skates
S - USB 4k wireless dongle
T - Extension adapter
U - USB charge / data cable
to customize the shape and feel.
A—Installed Out-of-box
Number Marking
Number Marking
DPI Presets
There are 4 default DPI presets: 400 DPI (Red) | 800 DPI (Blue) | 1600 DPI (Yellow) |
3200 DPI (Green). Max DPI: Up to 26000 DPI.
HyperX NGENUITY Software
To customize lighting, DPI, macro settings, and more, download HyperX
NGENUITY software at hyperx.com/ngenuity
Questions or Setup Issues
Contact the HyperX support team or see the user guide at hyperx.com/support
Battery Replacement
1. Switch power mode to "OFF".
2. Remove the mouse skates with a at, plastic tool (e.g. spudger, ngernails) to
reveal and unscrew the 4x Torx 6 Security screws below.
3. Remove the Shell and Button Cover to reveal and unscrew the 2x Philips screws
at the top of the mouse. Separate the top piece from the mouse.
4. Gently separate and lift the top shell from the bottom shell, in an upward
motion
5. Locate and remove the battery secured with a connector.
6. Place new battery matching correct pin orientation.
7. Close bottom and top case of the mouse. Reverse step 3 and 2.
8. Turn on the Mouse and test for functionality.