Cleaning; Storage; Troubleshooting; Transport - Walter Wws-Gp600-R02 Bedienungsanleitung

Cleaning

CAUTION!
Make sure that liquids do not get inside
the control unit.
• Drain the garden pump completely before
cleaning it.
• The product has to be cleaned when necessary,
but at least once a month. For cleaning, rinse
the product thoroughly with water.
• Clean the product with a moist cloth. Never
use strong and / or abrasive cleaning agents or
solvents. Allow all the parts to dry completely.
• Make sure that the ventilation slots are open.
• Clean the body regularly with a soft cloth.

Storage

• Remove the lines before storing each time (see
chapter "Connecting / removing suction and
pressure lines).
• Drain the remaining water by opening the drain
plug 6 .

Troubleshooting

Problem Possible cause
Motor is not No mains voltage.
starting.
Low suction Pump not filled adequately with the liquid
power. to be pumped.
Pump is drawing air.
Air cannot escape from the delivery line.
Suction line not in the medium to be
pumped, missing or faulty non-return
valve, suction line kinked, connections not
sealed or suction filter clogged.
Low pumping Leakage on the suction side.
volume.
Too little pumping medium on the suction
side.
Suction filter or non-return valve clogged. Remove the blockages and / or dirt.
630977_Anleitung_Kern.indb 23 630977_Anleitung_Kern.indb 23
• Clean the garden pump before storage.
• If the garden pump is not being used, keep it in
a safe, cool, dry and well-ventilated place, out
of the reach of children.
• Store the garden pump at an ambient
temperature of 0 - 40° C.
• After prolonged storage, the free movement of
the rotor has to be checked by briefly switching
on / off.

Transport

• Remove the lines before transporting each time
(see chapter "Connecting / removing suction
and delivery lines).
• Drain the remaining water by opening the water
draining plug 6 .
• Transport the garden pump in an upright
position and safeguard it against shocks and
vibration.
• Always carry the garden pump using the handle
1 provided for this purpose.
Rectification
Check the voltage.
Fill the pump.
Check and seal all the connections on
the suction side.
Open the shut-off valve / loads on the
delivery side.
Check the suction line and connected
accessories and remove any dirt and
rectify leaks.
Rectify the leak.
Reduce the discharge volume on the
delivery side.
Troubleshooting
8
12.11.2024 09:46:26 12.11.2024 09:46:26