Amewi Super Mono X V3 Rennboot Bedienungsanleitung Seite 9

INSTALLING THE 11.IV
(Always turn on transmitter
connecting the battery with ESC)
1) Remove Super Mono X 's upper deck by
rotate the plastic lock at its rear section.
2) Insert the 11.1 V LiPo into the left side of
the hull. Tie the power pack with
provided hook and loop strap inside
the hull.
3) Attach the 11.1 V LiPo's connector
matching connector in Super Mono X.
Listen for three continuous
(Signal noise of auto detected ESC)
5) Re-position the upper deck.
NOTE: I. There is a water proof rubber ring placed along the slot of hull, always make sure it's secured positioned
before re-position the upper deck.
2. It is suggested that don't leave the rubber ring in the slot of hull. Remove the rubber ring when not racing
the boat, so as to keep the rubber ring flexible for water proof effective.
TRANSMITTER/RECEIVER
The binding process effectively ties the transmitter and receiver together. Under normal circumstances, both
items are supplied ike this from the factory. If, however, you find that your transmitter and receiver are not
bound(receiver's red LED is on), you should do the following:
I) Switch "ON" the transmitter.
2) Switch "ON" the receiver by Attaching the 11.1V LiPo'sconnector to the matching connector in the Super Mono X.
3) Pressdown the "BIND" button on the receiver, the receiver's green LEDwill be on to indicate that binding has
been successful and the receiver will now accept commands from the transmitter.
Note 1: During binding process,transmitter and receiver should be no more than one meter apart and no other
similar devices
Note 2: if the green light flashing, showing the binding failure, pleasedo again asabove indication.
AMEWI Trade e.K.
LIPO IN THE SUPER
before
to the
"BE, BE, BE"
BINDING
should be within 10 meters.
Nikolaus-Otto-Str. 18
MONO X
BE BE BE
33178 Borchen /Germany