Amewi Super Mono X V3 Rennboot Bedienungsanleitung Seite 11

LUBRICATING DRIVE
Lubricating the flexshaft is vital to the life of the drivetrain. The lubricant
also acts as a water seal, keeping water from entering the hull through
the stuffing tube. Lubricating the flexshaft, propeller shaft after every
2 or 3 times of operation.
1. Use the 2mm Allen key to loose the two grub screws of the coupler
which connects the flexshaft, then slide the flexshaft w/ prop shaft
out of the stuffing tube.
2. Lubricate the flexshaft w/ prop shaft with the water proof marine
grease, reinstall the flexshaft w/ prop shaft in reverse order, be sure
to retighten the two grub screws of coupler.
IMPORTANT
The bearing in the water
must be regularly lubricated
Vaseline petroleum
through the ingress
Insufficient lubrication
premature failure Of the bearing.
Note: Image shows
clarity - the bearing
drive shaft in situ.
CAUTION!
Please observe the following warnings.
DURING OPERATION
• The transmitter's range wil vary depending on your surroundings and battery strength.Do not operate
Super Mono X too far away or control will be lost.
• Ensure that all batteries are correctly installed and that the 11.1V LiPo is fully charged.
• Do not operate your Super Mono X in areas with strong currents, in salt water or areas of water with
large waves.
• Do not touch moving parts during operation, especially the propeller.
• Do not let your Super Mono X runs aground, as this can cause damage.
f you lose control of your Super Mono X , never wade into deep water or water with strong currents to
retrieve it. First, hold the transmitter
find another way to move closer to the model, but do not endanger yourself in the process!
GENERAL INFORMATION
Please follow these simple rules to ensure safe operation and gain the maximum enjoyment from your
model.
• Avoid overloading your model. Never run it in areas where its movement will be restricted, e.g. areas where
there is pond weed, etc., as this can over stress the motor.
• Ensure nothing prevents the smooth running of moving parts.
• Do not run your model in confined spaces.
• Never run your model in a public spacewhere it might upset or endanger people or wildlife.
• Immediately switch 'OFF'your model and transmitter
Never use your model in the rain.
Do not dismantle or tamper in any way with this R/Cvehicle and its transmitter. The manufacturer and distributor
will accept no responsibility, expressed or implied, for accidents or injuries caused as a result of disassembly,
modification and/or usage against the Instructions for this product.
Tamperig or modification
AMEWI Trade e.K. - Nikolaus-Otto-Str.
SHAFT
• Super Mono X
cooled motor mount
with oil, grease
jelly to prevent corrosion
of water.
may lead to the
drive shaft removed for
can be lubricated with
as high as you can to try to re-establish control. If this does not work,
FOR THE SAFE OPERATION
will also invalidate the
18
or
the
OF YOUR SUPER
if you see lightning or hear thunder.
uarantee.
33178 Borchen /Germany
MONO X