Amewi Super Mono X V3 Rennboot Bedienungsanleitung Seite 10

TURN FINS
Super Mono X features adjustable turn fins to aid in turning.
These can be adjusted using the included Allen key.
The optimum angle of adjustment is 45 degrees to the hull.
DRIVING YOUR SUPER
I) Switch 'ON' the transmitter. Check that the transmitter's red LED glows brightly.
2) Check that Super Mono X 's turn fins are adjusted correctly.
3) Switch 'ON' Super Mono X(connect the 11.1V LiPo).
4) Check that the propeller and the rudder respond to transmitter inputs before placing Super Mono X
on the water.
AFTER USE
1) When you have finished using your Super Mono X,you should first switch 'OFF' the model (disconnect
the 11.IV LiPo),then switch 'OFF' your transmitter.
2) Remove all batteries
3) Leave Super Mono X 's upper deck off to allow moisture to evaporate. Ideally, place the model in this
way in a warm and dry place, like an airing cupboard, until you are sure it is dry and then store it away.
4) Remove the rubber ring from the slot of hull, so as to keep the rubber ring flexible for water proof effective
in next time boat racing.
NOTE: If Super Mono X begins to bob when running, it may have taken on an excessive amount of
water. In this case, you should immediately return to shore, remove the upper deck and drain the water from
the hull.
IF THE SUPER MONO
Ifyour Super Mono X does not run in a straight line
when not being steered,you can adjust it by using
the steering trim located
AMEWI Trade e.K.
MONO X
from the transmitter and model.
X DOES NOT RUN IN A STRAIGHT
Nikolaus-Otto-Str. 18
LINE
Throttle trim&ake
Throttle trim-forward
Power indicator
33178 Borchen /Germany
Steering reverse switch
Rev N OR
o
srrTR'M
010
Steering trim-left
-O
Steering traveling angle-right
-O
POWER Steering traveling at*left
STL
Power switch