Rollei LUX 60 RGB Bi-Color Anleitung Seite 56

Structure and Possible Combinations
56
Additional Equipment
Connecting the mains adapter
or USB­C cable
– Connect the mains adapter to the DC
connection [13] .
Take care not to leave the mains
adapter hanging in the air . Use the wire
ring to attach the mains adapter to the
lamp tripod .
– Connect a USB-C cable to the USB-C
port [12] on the COB permanent light .
Note: Only use a USB power adapter
with at least 65 W output power .
Connecting the battery handle 71 Wh
– The LUX battery handle 71 Wh is only compatible with the LUX 60
W and LUX 100 W lamp series .
– Make sure that the LUX battery handle is switched off before
installing it . Only switch it on after it has been attached to the
lamp .
– Align the battery connector and 1/4' screw on the top of the LUX
battery handle with the battery connector and 1/4' connector [7]
on the lamp . Then turn the locking wheel [18] to lock it in place .
Make sure the locking wheel [18] is securely in place before
turning on the battery handle .
– To remove the battery grip, turn the locking wheel [18] in the
opposite direction .
1
Align
2
Unlock
3
Lock
ENGLISH
1
3
2