Meec tools 021743 Bedienungsanleitung Seite 74

EN
E8
BP
EE
E9
E12
E13
E14
LOCK
74
Docking unsuccessful.
Battery temperature too high
or too low.
Error unknown.
The mower is stuck.
Problem with the battery.
Charging error.
Working area is too large
Entered the wrong code too
many times.
1. Make sure there is at least 1 m of straight
perimeter wire and no obstacles in front of
and behind the charging station – this is
necessary for correct docking.
2. The charging station must be positioned
on level, horizontal ground. It must not be
installed on a slope. The surface must be
flat so that the base plate is not buckled or
creased.
3. Manually dock the robot lawn mower in
its charging station. When the battery is fully
charged, press START and OK.
1. Check the battery temperature. If the
battery is too hot, wait for it to cool down. If
the battery is too cold, wait for it to heat up to
at least 5°C. Then press START and OK.
2. If the error code is still displayed, replace
with a new battery. Press the power switch.
Then press START and OK.
3. Contact your retailer if the error repeatedly
occurs.
Press the power switch. Then press START and
OK. Contact your retailer if the error persists.
Move the mower to an area free of obstacles.
Change the battery.
Clean the charging head/pole.
Decrease the working area for the mower.
1. Wait for 10 minutes.
2. Enter the correct code.