Testing The Installation - Meec Tools 021743 Bedienungsanleitung

EN
Status light is off:
- No power supply. Check that the low voltage
cable is correctly connected to the charging
station and that the cable is correctly plugged
into a suitable and live power outlet.
Steady green light:
- The perimeter wire is correctly connected
and the robot lawn mower's battery is fully
charged.
Flashing green light:
- Automatic charging in progress.
Flashing red light:
- The perimeter wire is not connected. Check
that both ends of the perimeter wire are
correctly and securely connected to the
terminals of the charging station.
Check there are no breaks in the perimeter
wire.

TESTING THE INSTALLATION

1. Set the maximum cutting height (60 mm)
when using the mower for the first time.
2. Place the robot lawn mower inside the
mowing area and start it.
3. Watch the mower to see how it moves
and whether it operates correctly within
the perimeter wire.
4. Cancel mowing mode and check that
the mower returns along the perimeter
wire to the charging station. If the robot
lawn mower returns to the charging
station and docks without any problem,
the installation has been completed
successfully.
FIG. 15
NOTE:
The product will sense and follow the cable
counterclockwise back to the charging
station.
FIG. 16
68
OPERATION
QUICK GUIDE (DISPLAY INTERFACE)
1. Time setting
2. Password setting
3. Power switch
4. Start/increase value
5. Go to charging station/reduce value
6. Confirm
7. Battery charge level
8. WiFi
9. Bluetooth
FIG. 17
Once the perimeter wire has been installed
in accordance with the instructions, the robot
lawn mower can be started.
1. Hold down the power switch until the
robot lawn mower turns on. The default
PIN code 0000 should be entered the first
time a new robot lawn mower is used.
2. Press OK four times when the digit 0 is
flashing. (The PIN code can be changed
by the user.
NOTE:
The robot lawn mower will automatically
turn off if it does not receive any input within
30 seconds of being turned on.
If an incorrect PIN code is entered 10 times, a
warning sound is emitted and the robot lawn
mower turns off.
3. Press START and then OK to start mowing.
4. Press HOME and then OK to stop mowing
and to send the mower back to the
charging station.
The robot lawn mower will continue to cut the
lawn until the battery level is low, at which
point it will return to the charging station. The
robot lawn mower will automatically resume
mowing once the battery is fully recharged, or
will remain in the charging station until it is
next scheduled to start mowing.
FIG. 18