VEVOR HJ-RB511BK Bedienungsanleitung Seite 8

⑫
⑭
⑬
Installation steps of panel down boards:

1.Align the positions of the four panel control holes into the luggage rack.
2.Put the meson gasket and hexagonal socket screw (M6x12) into the hole from
the front of the luggage rack, screw in the flange nut (M6) from the back, and then
tighten the screw with a hexagonal key wrench. According to the requirements of
this sequence, install screws on all holes on the panel in turn and tighten them.
㉔
⑭
Screw board
㉖
Installation step of the bottom support:

1.Install the iron plate nut into the bottom slot of the left and right lower rods;Move
the iron plate nuts that have been put into the grooves of the left and right lower
rods to a suitable position.
2.After adjusting the position of the iron plate nut, install the bottom support, and
install the Allen screw (M6x10) and M6 gasket and lock it with the iron plate nut
with a hexagonal key spanner.