VEVOR HJ-RB511BK Bedienungsanleitung Seite 6

Installation step of rear upper & down bar：

1.Install the rear upper bar and rear down bar into the rear plastic connector and
lock them with self-tapping screws and meson gaskets.
㉖
⑮
⑥
Installation steps of left and right upper bars, left and right down bars:

1.Install the plastic adaptor into the left/right upper bar and left/right down bar, and
lock it with self-tapping screws and meson gasket.
2.Install the left and right upper and lower bars into the installed installation
self-tapping screws and meson pads for the installed front plastic connector and
lock it with the locking tabs.
3.Install the iron plate nut into the concave of the left and right lower bars
respectively at the groove (Note: 4pcs shall be installed on the left and right
respectively, and iron the convex point of the disc nut faces inside the groove).
4.Install the left and right upper and lower bars
connector is locked with self-tapping screws.
⑭
⑦
⑪
into the installed rear plastic
⑭
⑪