Additional Assembly Information; Additional Environmental Information; Adjust Tank Water Level; Filling The Tank With Water (Fig� E-3) - Tunturi R85W Rower Dual Rail Montageanleitung

English

Additional assembly information

Fasten Nuts and Bolts
To prevent mounted frame parts from not being
correctly aligned, it is advisable to complete the
first subsequent steps before fully tightening
nuts and bolts. This provides space to reposition
previously mounted parts, allowing the overall
assembly to proceed more smoothly. Therefore it
advisable to follow up on the below instructions.
DO TIGHTEN ALL BOLTS AND
NUTS IN THIS STEP AND BOLTS
AND NUTS OF FORMER STEPS
DO NOT TIGHTEN BOLTS
AND NUTS IN THIS STEP

Additional environmental information

Packaging disposal
Government guidelines ask that we reduce the
amount of waste material disposed of in land fill
sites. We therefore ask that you dispose of all
packaging waste responsibly at public recycling
centres.
End of life disposal
We at Tunturi hope you enjoy many years of
enjoyable use from your fitness trainer. However,
a Time will come when your fitness trainer will
come to the end of its useful life. Under 'European
WEEE Legislation you are responsible for the
appropriate disposal of your fitness trainer to a
recognised public collection facility.

Adjust tank water level

Filling the tank with water (Fig� E-3)
- Remove the rubber tank plug from the top of
the tank.
- Place a large bucket of water next to the rower
and position the siphon with the rigid hose in
the bucket and the flexible hose into the tank as
14
Securely tighten all
nuts and bolts after all
components have been
assembled in current
and previous steps.
Do not fully tighten all
nuts and bolts used in
this step.
Hand tight is enough.
shown. Make sure the small breather valve on
the top of the siphon is closed before filling.
‼
NOTE
• 17 liters of water is required for maximum
filling.
• Where water quality is poor, we recommend
using distilled water.
• Putting the bucket higher than the tank will
allow the siphon to "self-pump" when adding
water to the tank.
• Consider using a towel under the bucket and
water tank preventing stains on the floor.
⚠
WARNING
• Filling the water level over the Maximum
level might result in water leakage during
workout.
- Begin filling the tank by squeezing the siphon.
Use the level gauge decal on the side of the
tank to measure volume of water in the tank.
- After filling the tank to the desired water level,
open the valve on the top of the siphon to
allow excess water to escape.
- Ensure that the tank plug is replaced once
filling and water treatment procedures are
complete.
Removing water from the tank (Fig� E-4)
- Remove the tank plug.
- Insert the siphon rigid hose end into the tank
- Insert the siphon flexible hose end into a large
bucket.
- Drain the tank (approx. 20% of water will remain
in the tank. It is not possible to drain the tank
completely without disassembling the tank)
- Refill the tank following the directions as
described under the section "Filling the tank"
of this manual.
‼
NOTE
• If the water treatment schedule is maintained,
it will not be necessary to change the water
inside the tank. An additional water treatment
tablet is only required when discolouration of
the water appears.
• Exposure to sunlight affects the water.
Moving the rower away from direct sunlight
will extend time between water treatments