Getting Started; Inserting The Batteries; Replacing The Batteries - Hama Rc200 Bedienungsanleitung

4. Getting Started

4.1. Inserting the batteries

• Open the battery compartment (14) and
remove the contact breaker. Replace the battery
compartment cover.

4.2. Replacing the batteries

• Open the battery compartment (14), remove and
properly dispose of the dead batteries and insert
two new AAA batteries with the correct polarity.
Replace the battery compartment cover.
5. Operation
Note
Hold down the  button (13) or the  button
(12) to select the values faster.
• Press the MODE button (11) repeatedly to switch
between the following displays:
• Temperature
• Alarm mode 1 (ALM1)
• Alarm mode 2 (ALM2)
• Dual Time
5.1. Automatic date/time setting using the
DCF signal
• Once you have inserted the batteries, the display
is switched on, an acoustic signal sounds and the
alarm clock automatically starts searching for a
DCF radio signal. During the search, the radio icon
(6) will ash. This process can take 3 to 5 minutes.
• When the wireless signal is received, the date and
time are automatically set.
Display
Display ashing
Display steady
Not displayed
4
Searching for the
DCF signal
Active
Successful -
signal reception
Inactive –
no signal reception
• Press and hold the °C/°F/WAVE button (10) for
approx. 3 seconds to start a manual search for the
DCF radio signal.
Note - Time settings
• If, during initial setup of the device, no DCF
radio signal is received within the rst few
minutes, the search is aborted. The radio icon
(6) will go out.
• If there are reception problems, we recommend
leaving the clock to sit overnight, since
interference is generally less at night.
• In the meantime, you can start a manual search
for the DCF radio signal at another location or
you can manually set the time and date.
• The clock automatically continues to search
for the DCF signal every hour. If the signal is
received successfully, the manually set time and
date are overwritten.
Note - Manual search
• The manual search is automatically aborted
after 3-5 minutes.
• Using the wave °C/°F/WAVE (10) frequently
will drain the battery. We recommend only
using this function to seek out an optimal
location for the device.
Note - Summer time
The clock automatically switches to summer time.
appears on the display as long as summer
S
time is activated.
5.2. Manually setting the date/time
• Press and hold the MODE button (11) for approx.
3 seconds until the hours display begins to ash.
• Set the following information in the order listed:
• Hours (2)
• Minutes (2)
• Year (5)
• Month (4)
• Day (3)