Master-Slave Mode; D) Sound-To-Light Mode - Renkforce v1384778 Bedienungsanleitung

8-channel DMX operation
DMX channel
1
2
3
4
5
6 (CH8 = 000-059)
6 (CH8 = 060-255)
7 (CH8 = 060-119)
8
c) Master-Slave Mode
• Select the desired operating mode in the menu of the master device.
• Activate the operating mode SLAV on all slave devices.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices.

d) Sound-to-Light Mode

• Set SOUn in the menu to operate the device in sound-to-light operation.
• Use Sd01-Sd30 to select the trigger sensitivity of the installed microphone.
The effect light is controlled via an installed microphone in time with the music in this mode.
Value Function
000-255 Brightness red 0-100%
000-255 Brightness green 0-100%
000-255 Brightness blue 0-100%
000-255 Brightness white 0-100%
000-255 Total brightness 0-100%
000-006 No strobe effect
007-065 Strobe speed slow > fast
066-069 Light off
070-128 Pulsing strobe effect slow > fast
129-132 Light off
133-191 Colour strobe with fade-in effect slow > fast
192-195 Light off
196-255 Colour strobe with fade-out effect slow > fast
000-255 Speed setting for channel 8
000 Light off
001-255 Colour selection (channel 8 = 060-119)
000-059 Channel 1-6 activated
060-119 Colour selection via channel 7 / strobe speed via channel 6
120-179 Colour change effect / speed via channel 6
180-239 Fade effect / speed via channel 6
240-255 Sound-to-light effect / reaction sensitivity via channel 6
29