Braun WelchAllyn ThermoScan PRO 4000 Base Station Bedienungsanleitung Seite 8

6021352_Pro4000_Base Seite 8 Montag, 22. Oktober 2007 8:14 08
8
thermometer will give a short beep and the yellow
charging indicator will light up.
The yellow indicator will continue to shine, showing the
thermometer's batteries are being charged. Once the
product is fully charged, the yellow indicator will go off.
If later on, it comes on again, this indicates that the
batteries are being recharged to maintain their full
capacity.
When in use, the thermometer's display may show
«RET» and the battery symbol. This means it has to be
returned to the station for charging.
Anti-theft function
The PRO 4000 Thermometer is equipped with an anti-
theft function. It requires returning the thermometer to
the base station within an individually pre-selected time.
Otherwise the thermometer will cease to operate.
When leaving the factory, the anti-theft function of the
PRO 4000 is turned off. This is how the function is turned
on or off and how the timing is set:
• Put the thermometer into the station and wait for the
long confirmation beep.
• Press the start-button on top of the thermo-
meter and keep it pressed while you take the ther-
mometer out of the station.
• When you release the start-button, the thermo-
meter's display will show the actual anti-theft time
setting. I.e. «H08» meaning 8 hours have been
selected as the time for which the thermometer can
be used before it has to be returned to the station.
• To change the setting, press the start-button again
and as often as necessary until the desired time is
shown in the display.
«H» means the anti-theft function is off, «H01» means
1 hour setting, etc.
• Release the activation button and place the
thermometer back into the station within 30 seconds.
A long beep will sound, confirming the setting.
If the setting is not confirmed, repeat the procedure
as described.