Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Battery status
Battery status is indicated by an orange LED on the
front of the integrator module. This LED will flash one
time when the unit is switched ON. The length of time
the LED is lit will increase as battery life decreases.
Continuous lighting of LED indicates low battery and
requires batteries to be replaced.
Battery replacement
Should you suspect a depleted battery or the low battery
LED blinking, proceed as follows.
1. Turn "OFF" all power to the unit and measurement
circuits.
2. Set the sensor selector switch to the "OFF" position.
3. Remove the flexible current sensor from around the
conductor wires of your measurement circuit.
4. Disconnect the flexible sensor at the applicable
Dranetz instrument.
5. Rotate the battery lock screw (1/4 turn) until it aligns
with the unlock symbol. The battery cover can now
be removed.
6. Remove the batteries from the battery holder.
7. Install the replacement batteries into the battery
holder.
8. Replace the battery cover and turn the battery lock
until it aligns with the lock symbol.
Seite 19 von 54
Werbung
