Advance PROTECT II RIS Betriebshandbuch Seite 37

Ideally, packing should be done on a parachute packing table. Failing
this a clean, static-free surface will suffice.
The following packing instructions apply to both the PROTECT II RIS
and the PROTECT NANO – with the envelope inner container with
the pilot chute, or the 4-flap inner container. New elastic bands must
be used each time the parachute is repacked. The following pictures
show a PROTECT II RIS model. More technical specifications about
the different models can be found in the <Technical details> chapter.
Caution: We strongly recommend that you let a trained
specialist pack your parachute.
Laying out and untangling
Lay the parachute out to its full length on the packing surface.
First make sure the middle line lies symmetrically in the apex (Pic 1).
Then run a spare piece of line through the packing loops and secure
it at the top end of the packing surface (Pic 2).
Pic 1
Pic 2
37