FISCHER CRASH SENSOR FIND.U Montage- Und Bedienungsanleitung Seite 16

5. SCOPE OF DELIVERY
• Crash sensor (with Li-Ion battery)
• USB-C charging cable (25cm)
• Adhesive pad
• Free FIND.U app (Android from version 5.0 / IOS from version 11.0)
6. BEFORE THE FIRST RIDE
6.1 Charging the sensor
Plug the charging cable into the sensor and charger/PC.
The charging process starts automatically.
6.2 Sensor mounting
Select a suitable adhesive surface on your helmet.
The area marked green in the illustration is suitable.
• Lower rear area
• Below the ear
• On the helmet shell
• Non-curved adhesive surface (At least . 75% of the
adhesive surface of the sensor must be in contact)
The USB-C socket on the sensor must point downwards in the
riding position. This prevents water and dirt from getting in.
The sensor must be positioned so that a charging cable can
be plugged into the USB socket.
Do not attach the sensor to the hard foam of the helmet.
The adhesive surface must be free of dirt and grease.
16
When the LED on the sensor flashes red/green, the battery is charging.
The battery is fully charged when the LED flashes green continuously.
Charge the sensor before each ride until the LED flashes green.
USB-C socket