Candy CF 4C6F1X Bedienungsanleitung Seite 130

If there is any break in the power supply
while the dishwasher is operating, a
special memory stores the selected
programme and, when the power is
restored, it continues where it left off.
End of the programme
The end of the programme will be indicated
by 3 signals lasting 3 seconds interspersed
with a pause of 20 seconds. After one
minute, the dishwasher will switch off. At
the same time the "END" message will
appear on the display for one minute.
Only for models with the SMART DOOR"
option, the door will open automatically
during the drying phase and you will
have to wait for the end-of-cycle signal
before removing the dishes.
"EXPRESS" button
(only on some models)
This button enables average energy and
time savings of 25% (according to the cycle
selected), reducing
temperature and the drying time during the
final rinse. This option is recommended for
evening washing when perfectly dry dishes
are not needed immediately. For better
drying, leave the dishwasher door slightly
ajar to promote natural air circulation in the
dishwasher.
HALF LOAD/SETTING
This key allows you to select two different
functions:
"HALF LOAD"
"HALF LOAD" button
(Only in models where present)
Specially developed for lightly soiled small
loads that fits approximately half the
the wash-water
button
130
of the dishwasher. Selecting this option can
save you time, energy and water.
After selecting the programme, press the
button and the indicator light will come on.
If this option is not compatible with the set
programme, a sound will be heard.
In models with the PRO version only, you
can also choose the washing basket.
Each time the half load button is pressed,
the wash basket will appear on the display.
Both baskets.
Lower basket.
Upper basket.
In models with a 3rd basket, it will
always be active.
SETTINGS
The dishwasher comes with certain factory
settings. However, you can adapt the
various parameters to your washing needs
from the settings menu.
The following parameters can be adjusted
(LANGUAGE → TABS → SOFTENER →
RINSE AID →
FUNCTION → INTERIOR LIGHT
*
Only in models where present
ALWAYS start the procedure with the
dishwasher turned off.
LANGUAGE SETTING
1. Switch the dishwasher on with the
"ON/OFF"
button.
2. Keep the "OPTIONS"
pressed for about 5 sec.
BUZZER → MEMO
*
).
button