Merach MR-R14 Bedienungsanleitung Seite 17

3. Water replacement
NOTE: When filling with water, use a dry cloth pad under the tank to prevent wetting floors
and carpets.
STEPS
① Remove the water tank plug.
② Insert the hose at the bottom of the electric water pump into the water tank of the rower,
and the outlet of the electric water pump into the water bucket.
③ Turn on the water pump to drain the water.
NOTE: When using the water pump, please charge it fully firstly and then press the top switch
button to ensure proper drainage.
Water Level Marker
·The resistance depends on the amount of water in the tank, please fill the water according
to the water level mark.
·Do not exceed this water level mark. If water is added above the maximum water level,
damage to the product will not be covered by the warranty.
EN
Water Injection and Management
Rubber plug
Water
injection
013