VEVOR RHF9021NS Bedienungsanleitung Seite 8

element (safety) of the tool to be placed on
the work piece.
2. The work contact element is then depressed against the work piece and
the trigger is pulled to drive the fastener.
3. The trigger is then released after each fastener is driven. Move the tool
to the next location where the fastener will be driven and repeat the
procedure.
CHECKING A CONTACT TRIP SAFETY TOOL
1. Disconnect air supply from the tool.
2. Empty fasteners from magazine.
3. Make sure the trigger and the safety move up and down without any
sticking.
WARNING:
Check and replace any damaged or worn components of the tool. The
safety warning labels on the tool must be replaced if they become
un-readable from wear.
4. Connect air supply to the tool.
5. Depress the safety against the work piece without pulling the trigger. The
tool must not cycle (fire). Never use the tool if a cycle occurs.
6. Hold the tool clear from the work piece. The safety should return to its
original down position. Pull the trigger, the tool must not cycle (fire). Do not
use tool if a cycle occurs.
LOADING THE TOOL
1. Connect the air hose.
2. Depress the magazine latch; pull back on the pusher until it latches at
back of magazine.
3. Insert a strip of fasteners into the magazine. Make sure points of
fasteners are in forward position. Also make sure fasteners are not dirty or
damaged.
- 7 -