VEVOR RHF9021NS Bedienungsanleitung Seite 11

1. Inspect Magazine; Clean magazine by removing any plastic or wooden
chips which may have accumulated in the magazine.
2. Make sure Pusher Lever operates smoothly in the magazine.
3. Check Safety Lever operates smoothly and freely up and down
4. Lubricate moving parts daily for proper operation of tool.
ADJUSTING AIR PRESSURE
Adjust air pressure at recommended operating pressure 70~120 psi
(4.9~8.3 bar) according to the length of nails and the hardness of wood.
Correct air pressure is the lowest pressure which will do the job. Using air
pressure higher than required to drive nails to proper setting puts
unnecessary stress on tool and parts.
TRIGGER SWITCH OPERATION DIAGRAM
- 10 -