VEVOR RHF9021NS Bedienungsanleitung Seite 4

Do not use oxygen, combustible gases, or bottled gases as a power source
for this tool as tool may explode possible causing injury.
Do not use supply sources which can potentially exceed 200 P.S.I.G. as
tool may burst, possible causing injury.
The connector on the tool must not hold pressure when air supply is
disconnected. If the wrong fitting is used, the tool can remain charged with
air after disconnecting and will be able to drive a fastener even after the air
line is disconnected possible causing injury.
Do not pull trigger or depress safety arm while connected to the air supply
as the tool may cycle, possible causing injury.
Always disconnect air supply: 1. Before making adjustments; 2. When
servicing the tool; 3. When clearing a jam; 4. When tool is not in use; 5.
When moving to a different work area to eliminate an accidental actuation
which may cause possible injury.
LOADING TOOL
WARNING:
When loading tool: 1. Never place a hand or any other part of your body in
fastener discharge area of tool; 2. Never point tool at anyone; 3. Do not pull
the trigger or depress the safety as actuation may occur, possible causing
injury.
The operator must not hold the trigger pulled on contract trip (Bump Fire)
mode except during fastening operation as serious injury could result if the
tip accidentally contacted someone or something, causing the tool to cycle.
Always keep hands and body away from the discharge area of the tool. A
contact safety (bump fire) tool may bounce from the recoil of driving a
fastener and an unwanted second fastener may be driven possible causing
- 3 -