VEVOR RHF9021NS Bedienungsanleitung Seite 10

1. Set the switching device under trigger to the full downward position
otherwise it will not operate properly.
2. With the tool off the work piece, pull the trigger lever. Depress the safety
lever against the work piece. THE TOOL MUST OPERATE (FIRE).
See Diagram for details.
SEQUENCIAL FIRE (SINGLE FIRE) ACTUATION POSITION
1. Set the switching device under trigger to the full upward position, other
wise it will not operate properly. TOOL MUST NOT LEAK AIR.
2. Remove your finger from trigger lever and press the safety lever against
the wood. TOOL MUST NOT FIRE.
3. Without touching the trigger lever, depress the safety lever against the
work piece. Pull the trigger. THE TOOL MUST FIRE.
4. Hold the trigger while separating the safety lever from wood, the drive
blade will remain in the down position.
5. Release your finger from the trigger lever, driver blade will return to the
top position.
ADJUSTING DEPTH OF DRIVE SAFETY
To assure that each nail is driven to the same depth be sure that;
1. Air pressure to the tool is consistent, a regulator is installed and working
properly in line with the tool.
2. The tool is always held firmly against the work piece. If nails are driven
too shallow or too deep into the work piece adjust the Safety Adjustment
Wheel on the Safety to desired depth.
See Diagram for details.
TOOL MAINTENANCE AND INSPECTION
- 9 -