Wohler RM 400 Bedienungsanleitung Seite 33

Start RM 400
Fig. 8: Drain cleaning
Important information
•
Switch FOR + handle down
Cable turns to the right and is retracted.
•
Switch REV + handle up
Cable turns to the left and is pushed out.
•
Switch REV + handle down
Cable turns to the left and is retracted.
•
Handle center / neutral
Cable rotating, no forward or reverse feed.
WARNING!
Do not form a large working arc with the cable.
The cable can jump under tension - risk of injury!
•
Press the foot pedal to start automatic feed or
automatic reverse feed.
•
When the cable has moved into the pipe so far
that the working bend is relieved, pull the ca-
ble out of the machine and form a new work-
ing bend.
ATTENTION!
Never insert the cable with pressure.
•
If there is slight resistance, center the handle
and let the tool work. If necessary, use a C-
cutter drill to loosen blockages.
•
If you feel the cable blocking when inserting,
immediately set the feed handle to "reverse"
and let the cable run reverse for approx. 20 -
30 cm.
Operation
EN
33