SimonsVoss SmartCD2.G2 Kurzanleitung Seite 28

7. Programme
9
The SmartCD2.G2 switches automatically from Bluetooth mode to
standby mode to save power if you press the button or if it is inactive for
about 15 minutes.
7. Programme
During programming, there should a minimum gap of around 10 cm
between SmartCD and the locking device; for SmartRelay it should be
around 30 cm and 70 cm for the block lock.
7.1 Programming with a PC or laptop
ü
ü
1. Start the programming process in AXM/LSM.
2. Follow the further instructions.
7.2 Programming with a Windows notebook/tablet
ü
ü
1. Export your locking plan from your PC to an external storage device
28 / 112
The programming device is ready for use.
Current version of the AXM/LSM software installed.
Programming device connected via USB (Bluetooth not active; see
}
Getting started [ 26]
Current LSM Mobile version installed on your notebook.
Programming device connected via USB (Bluetooth not active; see
}
Getting started [ 26]
(e.g. USB config device).
).
).
Programming device
SmartCD2.G2
EN