SimonsVoss SmartCD2.G2 Kurzanleitung Seite 26

6. Getting started
6. Getting started
Operated via a USB port
SmartCD2.G2 can be directly connected to a PC or laptop by plugging
the supplied cable into an unassigned USB port.
All digital locking devices and all active transponder media in
SimonsVoss System 3060 can be programmed using a SmartCD2.G2 in
conjunction with a PC/laptop.
ü
ü
1. Unplug the USB cable from the SmartCD2.G2.
2. Press the button once if the top LED lights up continuously.
3. Plug the USB cable into the SmartCD2.G2 again.
26 / 112
AXM/LSM software is installed (drivers are also installed).
SmartCD2.G2 is charged (see
Top LED flashes and does not light up continuously.
9
Programming device
}
Recharging [ 25]
).
SmartCD2.G2
EN