BWT F1 SONIC PRO Bedienungsanleitung Seite 3

Charge
1. Fully charge the robot for 5 hours before first use.
2.
To ensure battery safety, keep the charging contacts
dry. You can wipe them with a soft, dry cloth. Before
charging, remove any water from the charging
contacts.
Use
Start cleaning
ƒ
ƒ The robot will automatically move to the edge of the
pool once cleaning is complete or when the battery
level is below 10%..
Automatic parking
1.
Press the power button for 2 seconds to turn on the
robot.
2.
Short press the power button to select cleaning mode.
3.
When the battery indicator flashes quickly, simply
place the robot in the water, and it will start working
automatically.
To remove the robot from the pool, attach a standard pole
(not included) to the retrieval hook and use it to lift the
robot out of the water.
IOS
1.
Hold the robot upright to drain the water.
2.
Open the filter cover and remove the filter from the
robot.
3.
Remove all dirt from the filter and rinse it with clean
water using a hose. If the filter is very dirty, clean it with
soapy water and a soft-bristled brush.
4.
Put the filter back into the robot and close the lid
properly for next use. Place the robot in a dry place and
let it dry completely. Do not place the robot in direct
sunlight.
Charging
Port
Press to
Press to
Android
F1SONIC PRO ROBOTIC POOL CLEANER
Power
Button
Timer
Floor Full Wall
Button
Cleaning mode
Icon
Clean the pool floor
Clean the pool floor and walls
Clean the pool walls and waterlines
Not lit: If not connected to Wi-Fi, it will run until
low battery; if connected to Wi-Fi, it will run for
the Auto estimated duration.
Lit on: Run for fixed 1 hour
Eco mode: The robot will run 30 minutes * 48
hours interval * 3 cycles of floor cleaning
Battery
Indicator
Eco Light
Timer Wi-Fi
Meaning
EN
3