BWT F1 SONIC PRO Bedienungsanleitung Seite 2

For your safety
1. Do not perform any cleaning or maintenance other than
the routine cleaning and maintenance described in this
manual. This product must be serviced by a licensed
and qualified pool equipment repair professional in
accordance with local laws.
2.
Use only original and authorized power adapter and
cable for charging.
3.
Do not use the product if the power cord is damaged.
Before charging, make sure the connector and socket
are dry and clean.
4.
Make sure the electrical outlet is protected by a
Ground Fault Circuit Interrupter (GFI) or a Ground Fault
Interrupter (GFCI).
5. Do not attempt to charge the F1SONIC PRO while the
robot is running. Ensure the power is turned off.
6. Do not dive into the pool while the robot is operating in
the pool.
7. Improper installation and/or operation may void the
warranty.
8. To reduce the risk of injury, do not allow children to
operate or ride on the robot.
9. When the robot is charging, it should be kept in a
cool place to avoid damage to the internal electrical
components due to overheating.
EN
10.
This appliance can be used by children aged from 8
years and above and by persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without
supervision.
11.
Do not attempt to replace the battery yourself. Contact
customer service if the battery needs to be replaced.
WARNING: Use only with the
DZ130AWL252450V battery charger
2
F1SONIC PRO ROBOTIC POOL CLEANER
Read the manual and follow the instructions
accordingly. In case of improper use, BWT is not
responsible for any loss or injury.
1.
This device must be installed and operated in
accordance with the specifications.
2.
This device must be installed to provide a separation
distance of at least 20 cm from all persons and must
not be installed or operating in conjunction with any
other antenna or transmitter.
3.
Under Industry Canada/Europe/Australia regulations,
this radio transmitter may only operate using an
antenna of the type and maximum (or lesser) gain
approved for the transmitter by Industry Canada/
Europe/Australia.
4. Any changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the device.
5.
When not in use, store the device in a shaded area
away from direct sunlight or any heat source. (We
recommend removing the device from the water after
each use.)
In the box
Operating
instructions