TROUBLE-SHOOTING
If you have any problems with your shredder, check the symptoms and remedies described below. If you are
unable to solve the problem this way, contact your nearest Kobra dealer. Do not open the head of the shredder
to attempt to repair it yourself. You could get a serious electric shock and invalidate your warranty.
PROBLEM
The shredder fails
to start
The shredder never
stops
Significant reduction
of shredding capacity
Documents are
not drawn in and
shredded
Compliant with
- directive LVD 2014/35/UE
- directive RoHS 2011/65/UE
- directive 2014/30/UE
The manufacturer
ELCOMAN SRL
VIA GORIZIA, 9 - 20813 BOVISIO MASCIAGO (MB) - ITALY
hereby declares that the KOBRA shredders listed below are compliant with the standards of directive LVD 2014/35/UE
- Kobra AF series: Kobra AF+1, Kobra AF.1, Kobra AF.2.
Standards applied are :
EN IEC 62368-1:2020+A11:2020
EN 55014-1 :2021
EN 55014-2 :2021
KOBRA AF
SIGNS
- The light (G) does not
come on
- Red light (I) comes on
- Light (G) comes on
- Light (G) on and
cutters in operation
- Capacity is less than
the declared capacity
- Documents remain in
the paper feeder tray
DECLARATION OF COMPLIANCE WITH EC STANDARDS
EN 61000-3-2 +A1 :2021
EN 61000-3-3 +A1 :2021
CAUSE
- Switch position ( H )
- Power cable not properly
connected
- No power
- Door (C) not closed properly
- Bag full
- Motor in heat protection mode
Material and/or dirt deposited
on or between the photocells
- Cutters dirty or adhesive on
blades
- Dirty belts covered in paper
dust
10
ACTION
- Turn switch to the position (I)
- Check that the cable is plugged
in properly
- Check that socket is switched on.
- Close the door properly
- Empty bag
- Wait 15 minutes for motor to
cool down
Remove the deposit from or free
the photocells
Clean the photocells with a brush
- Carry out maintenance by
inserting a sheet of paper
sprinkled with lubricant
-
Turn the belts manually and
clean them carefully with a damp
cloth
Bovisio Masciago, 31.01.2024
A. De Rosa
TECHNICAL OFFICE