5.
Disconnect the OEM controller
and remove it from the handlebar.
Proceed to install the GET Kill
Button included in the kit.
Connect the GET Kill Button
connector to the OEM harness
near the steering stem.
WARNING After installation, make sure the
wiring does not restrict the free movement of the
handlebar in either direction
6.
Install
CONTROLLER
the instructions in the "SX1
CONTROLLER Installation" section
of the GET SX1 Pro manual.
Connect the SX1 CONTROLLER
connector to one of the two
connectors on the GL-264-AA
harness previously routed to the
front of the bike.
7.
Install the GET SX1 CONNECT
by following the instructions in
the "SX1 CONNECT Installation"
section of the GET SX1 Pro manual.
Connect
the
connector to the second unused
connector on the GL-264-AA
harness previously routed to the
front of the bike.
GET
the
by
following
SX1
CONNECT
SX1
HARNESS
GL-264-AA
HARNESS
GL-264-AA
5
SX1
CONTROLLER
SX1 CONNECT
EN