Cooper Hand Tools Weller PYROPEN JR Bedienungsanleitung Seite 3

HOW TO USE THE TOOL AS TORCH
SWITCH
1. Loosen knurled cap to remove tip and tip housing.
2. Push up switch ring marked A and turn to right. Gas will start to
flow. Set mark 0 between "ON" — 1.
3. Ignite by using a match or lighter as shown in above illustra-
tion.
4. Adjust amount of flame by switch ring (1-3).
To turn off, slide the switch ring to "OFF" position.
5.
CAUTION
1. Do not fill gas or store near open flame, heater, furnace or
combustible materials.
Do not storeat places under direct sunshine or any placesthat
will exceed 400C.
2. Do not store the Pyropen Jr. in the dash-board of a car.
3. Keep out of reach of infants.
4. When not in use, be sure that switch ring is at "OFF" position.
5. When starting operation in winter or at cold-places (at about
or lower), it may be hard to ignite the gas. This is because
of butane gas nature. Hold handle in warm hand until the gas
will start to evaparate. Be sure,however, not to try to warm up
at open flame or in hot water.
The catalyser is delicate and can easily break.
6.
7. Do not usealcohol to clean the Pyropen Jr.
8. When usinga soldering tip or a hot blow tip, hot air
comes out from the exhaust hole in the tip. Be sure to
keep clear from the hole to avoid burns.
VARIOUS TYPES
Soldering tips: %pered needle
Chisel
Spade
Chisel
Hot blow tips: Hot blow tip
Hot blow tip
RING
TROUBLE SHOOTING
Trouble
No gas flow
Torch flame has
no power
Impossible to ignite
Tip does not heat up
OF INTERCHANGABLE TIPS
Cat. No.
(0.5 mm) 71-01-01
(3.0 mm) 71-01-02
(3.0 mm) 71-01-03
71-01-04
(5.0 mm)
(1.5 mm) 71-01-50
(4.9 mm) 71-01-52
Correction
Possible reason
Empty gas container Refill
Gas container Refill
probably almost empty
Gas pressure is too Adjust correctly
high or too low Position 1-3
Catalyser is damaged Replace
soldering tip
Insufficientgas power Refill