Cooper Hand Tools Weller PYROPEN JR Bedienungsanleitung Seite 2

INSTRUCTIONS
GEBRAUCHSANLEITUNG
MODE D'EMPLOI
ISTRUZIONI
GEBRUIKSAANWIJZING
INSTRUCCIONES PARA EL MANEJO
BRUKSANVISNING
GAS FILLING
Use original Weller Pyropen gas.
1.
2. Be sure that the switch ring is in "OFF" position.
3. Hold the Pyropen Jr. handle with tip pointing downward, refill
nozzel in upright position. Insert nozzel of gas container and
press down.
4. As soon as the PyropenJr.is filed, gas will flow over.
5. Hold the tool firmly and seethe window to read LPgas volume
inside.
HOW TO USE SOLDERING TIP AND
c
IGNITION VENT
KNURLED NUT
I. Push up switch ring markedA andturn to right. Gas will start to
flow. Set mark 0 between "ON" —I.
2. Push knurled cap marked B fully upward. Be surenot to cover
air take-in hole (marked C), as flame will leak out ignition vent
and catalyst will not react (seeillustration below).
3. While holding the knurled cap upward, ignite ignition vent by
using a match or lighter.When the inside of ignition vent turns
red, releasethe knurled ring. It will return to its original position
and generate heat.
4. Adjust tip temperature by moving the switch ring (I -3).
TOturn off, slide the swich ring to "OFF" position.
5.
6. Forany job with hot air replace soldering tip by hot blow tip.
HEAT TIP
SWITCH RING