Battery Preparation - Deerc D20S Gebrauchsanweisung

/ OPERATIONGUIDE
2.1 Battery Preparation >>
Drone Battery
USB Adapter
(5V/2A)
Power Bank
Remove the battery from the drone and connect it to a USBcharging
Plug the USB charging cable into a USB charging
adapter (5V/2A).
The red light on the drone battery il uminates
the battery is ful y charged
@ Charging time: About 150minutes.
*Low Battery Signal: The indicator lights on the drone keep flashing, and the transmitter
will keep beeping.
• Before charging, please read the instructions in the •Battery Safety• section Of the "Disclaimer
and Safety Guidelines" careful y!
• DO NOT charge a battery •mmediate y after a flight as the temperature
Please wait until it cools down to room temperature before charging again.
• Please use the origina charging cable to charge the battery.
07
cable.
port on a power bank or a USB
during charging and goes off once
may be too high.
2.1 Battery Preparation >>
Changing Transmitter Batteries
open the battery cover on the back of the transmitter. put in three AAAbatteries (not
included). Then,close the cover.
*Low Battery Signal: The indicator lights on the transmitter
• nstal batteries careful y.
Do not mix old and new batteries.
• Do not mix different types of batteries.
OPERATIONGUIDE /
flash slowly.
08