Note: Make sure that the unit is secure with a sturdy strap in your vehicle
while traveling.Make sure that the unit is placed on a flat surface, upright
and level, and never install on its side.
BACKFLUSH
WATER HARDNESS TEST
Use the water hardness test strip for the following:
To check the water quality of the water source
1
To check the quality of the water output from the portable RV
2
Water softener from time to time. If the water is hard, regeneration is needed.
WATER HARDNESS TABLE
Classification
Soft
Slightly Hard
Hard
Very Hard
REGENERATION
Disconnect the hoses connected to the unit.
1
Remove the cap/head.
2
Fill the tank with 52 oz(1471.6g) table salt.iv. Return the cap/head.
3
Reconnect the water source to the inlet port on the tank cap/head.
4
Backflush the unit every 3 months for 3 to 5 minutes.
Connect the water source to the outlet port on the
1
tank cap/head.
Turn the water on with high flow for high pressure
2
and faster washing.
Grain Per Gallon (GPG)
0 to 3
3to 7
7 to 11
>11
- 7 -
Parts Per Milion (PPM)
0 to 60
61 to 120
121 to 180
>181