INKBIRD ITC-308 Bedienungsanleitung Seite 8

05 1 Key Operation Instruction
5.1 Setpoint Query
When the controller is working normally, short press " A
key for one time, then the heating
displayed; short press " V " for one time, then the cooling
differential (CD) will be displayed.
normal display mode after 2 seconds.
5.2 How to Set
Step 1: While controller working, start to set after pressing
"SET" key for over 3 seconds. The indicatior light will on.
Step 2: Make sure there are showing "T S" on PV window while
setting value.
Step 3: Setting parameters to your requirement by pressing " A '
key, " V " keyo
Step 4: Saving parameters by pressing "SET" key over 3 seconds.
Please notice that it will back to display mode and save nothing
if you couldn't set parameters within 10 seconds.
5.3 Setup Flow Chart
Press "SET" key for ove
3 seconds to enter
paramerers set up mode
TS
250C
2.ooc
CD
2.ooc
99 oc
differential
The screen will return to
Parameters
Temperature
Set
Heating
Differential
Value
Cooling
Differential
Value
Alarm High
Limit
6
( HD) will be
AL
Alarm Low
Limit
-40 oc
Compressor
Delay
3 minute
CA
Temperature
Calibration
ooc
SE
CF
Temperature
Unit
c
Working
Normally