INKBIRD ITC-308 Bedienungsanleitung Seite 10

When the measured
set value) + CD (cooling
enters refrigeration
and refrigeration relay starts to work; when the cool
indicator light is flickering,
equipment is under compressor
When the measured
set value), the cool indicator
refrigeration relay stops working.
When the measured
value)-HD (heating
heating status, the heat indicator
relay starts to work;
TS(temperature setting),
and heating relay stops working.
For example, set TS=250C,
when measured temperature
(TS+CD) , system enters refrigeration
temperature decline
measured temperature
system enters heating
to 250C(TS), stop heating.
In case the time interval
than P T, please refer to 6.3.
6.2 Alarm High/Low
When measured temperature
temperature alarm will be triggered,
tone "bi-bi-Biii" until the temperature
any key is pressed.
When measured temperature
temperature alarm will be triggered,
tone "bi-bi-Biii" until the temperature
pressed.
6.3 Compressor
Under refrigeration
temperature is higher than the value of setting temperature
(T S) plus cooling
refrigeration immediately,
temperature PV > TS(temperature
differential
status, the cool indicator
it means
delay protection
temperature PVSTS (temperature
light will off, and the
temperature PV<TS
differential value),
light will on, and heating
when the measured
the heat indicator
CD=20C
is higher or equal to 27 OC
to 250C(TS), stop refrigeration;
is lower or equal to 22 oc (TS-HD)
status; when the temperature
between two refrigeration
Limit Setting
is higher or equal to AH, high
is lower or equal to AL, low
Delay (P T)
mode, after power on, if the measured
differential(CD), the equipment
but waiting
8
value), system
light will on,
the refrigeration
status.
(temperature
system enter
temperature
light will off,
, and HD=30C, then
status; when
when
raised
is less
(AH, AL)
buzzer will alarm
is lower than AH or
buzzer will alarm
>AL or any key is
won't start
for a delay time.
set
with
with