ULTIMATE SPEED OBDII USOBD A1 Bedienungsanleitung Seite 57

˜ First set-up of the product
˜ Unpacking the product
1 . Take the product out of the packaging and remove all
packaging materials and plastic wrappings .
2 . Check to make sure that all listed parts are included (see
"Scope of delivery") .
3 . Check whether the product and all parts are in good
condition, if any damage or defect is detected, do not
use the product, but follow the procedure described in
chapter "Warranty" .
˜ Preparation
˜ Location of the Data Link Connector
(DLC)
the center of the instrument panel(dash),above or around the
driver's knees for most vehicles .
˜ Operating the product
1 . Selecting a menu item:
Press
2 ] [
2 . Confirming the selection: Press
56 GB/IE
It's used to check engine of all vehicles
that comply with OBD ll . 12 V voltage with
standardized 16-cavity connector
Location of the Data Link Connector (DLC)
The DLC is usually located 12 inches from
or .
3 ] [
.
5 ] [
.
7 ] [