Maintenance; Cutter Blocks; Cleaning; Oil Level Check - Vevor Rc-16 Benutzerhandbuch

advance piston. Unplug unit. And check piston and housing for accumulated dust
iron filings that may be jamming the piston. After cleaning, piston still does not
automatically retract when fully extended, the piston itself may be damaged.
Return the unit to an authorized agent for repair.

Maintenance

Cutter blocks

Before using, always check that the two bolts on each cutter block are properly
tightened. Using a loose block will result in damage to block and housing. Also
check condition of cutter blocks. If either cutting edge is dull or chipped, remove
retaining bolts and rotate both blocks so that two new edges come into use.
Replace and tighten bolts (each block has four cutting edges)
When all four cutting edges have been used or if either block is cracked or
otherwise damaged, replace both block.
! Caution: A loose or cracked block may injure the operator .

Cleaning

Cleaning cutter after use.
! Caution: Wear gloves to protect hands from metal splinters. Do not use an
air-gun, blasting with air can cause metal filing and/or dust to get into eyes and
respiratory system.
1.Disconnect unit.
2.Wipe or brush away all dirt and metal filings. Pay particular attention to the lower
half of the piston, where dirt is more easily accumulated.
Oil-level check
As the cutters are hydraulically operated, the oil level must be checked at frequent
intervals, preferably daily. Failure to maintain the oil properly results in a drop in
pressure and loss of cutting power.
! Caution : Hydraulic oil is highly flammable. Keep away from sparks and naked
flame. Do not smoke.
! Caution: Hydraulic oil may cause inflammation of the eyes and skin. If ingested,
- 11 -