EN
Australia, New Zealand
Rain shield must be removed when indoors and in hot weather to prevent overheating and
possible risk of suffocation.
Children should not be left unattended in the product with rain shield fitted.
To avoid instability of the stroller, only attach one weight bearing accessory to the stroller
handle bar at a time.
Excessive weight may cause a hazardous unstable condition to exist. The product will
become unstable if the manufacturer' s recommended load is exceeded.
Unit may become unstable if the manufacturer' s recommended load is exceeded, or if a
parcel bag, accessory, or rack other than that recommended by the manufacturer is used or
hung from the unit.
Any load attached to the handle affects the stability of the stroller.
It is unsafe to use accessories other than those approved by UPPAbaby.
When using the Vista in double mode, load the child into the upper seat before loading
the second child into the Rumble Seat.
DO NOT have a child in the lower seat without having a child in the upper seat.
DO NOT allow child to stand while in the Seat.
Extreme care should be taken if the stroller is used on stairs or an escalator.
NEVER leave child in the product while ascending or descending stairs, or using an escalator.
The stroller is designed for use on flat or gently sloping surfaces and may be unstable on
higher sloping and uneven surfaces and could tip over if on sloping, unstable or uneven
surfaces.
The stroller should not be used near an open fire or exposed flame.
Audible "click" must be heard to confirm that each attachment is connected properly.
Ensure that all the locking devices are engaged before use.
Children and adults should be clear of moving parts while making stroller adjustments.
If not properly executed, damage to fingers or extremities may occur when opening or
closing the stroller frame.
Before each use, inspect your RumbleSeat to make sure the brackets are fully
engaged by pushing down on the top of the RumbleSeat firmly. It should not move.
Make sure latch on left side of stroller is properly engaged before lifting or carrying the
vehicle
Stroller can fold with adapters attached, however, the RumbleSeat must be removed and
the main seat must be facing forward and in an upright position.
Always push the pushchair with both hands when using the RumbleSeat.
DO NOT lean or press on the RumbleSeat with excessive force.
DO NOT make any alterations or modifications to the stroller with products not supplied
by the manufacturer as this may cause instability or structural damage not covered under
warranty.
Use only replacement parts supplied or approved by UPPAbaby.
Complies with AS 2088 and TPA 1974 NO. 8 Consumer Product Safety Standard for Prams
and Strollers.
19