Know Your Product - Ryobi Rjs850 Bedienungsanleitung

■
After each period of operation, exercise to increase
blood circulation.
■
Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
WARNING
Injuries may be caused or aggravated by prolonged use
of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.

KNOW YOUR PRODUCT

See page 66.
1. Trigger switch
2. Lock-on button
3. Speed control dial
4. Blade clamp releaser
5. Blade guard
6. Blade
7. Allen key
8. Power cord sleeve
9. Blower switch
10. Orbital adjustment knob
11. Base assembly
12. Dust port
13. Line assist assembly
14. Handle, insulated gripping surface
MAINTENANCE
WARNING
The product should never be connected to a power
supply when assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
serious injury.
WARNING
When servicing, use only original manufacturer's
replacement parts, accessories and attachments. Use of
any other parts may create a hazard or cause product
damage.
WARNING
Do not at any time let brake fl uids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
4
Original Instructions
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
■
Always wear safety goggles or safety glasses with
side shields when operating or cleaning the product. If
operation is dusty, also wear a dust mask.
■
Clean the product using a brush or a dust collection
system.
WARNING
Do not use compressed air to blow dust/dirt from any
power tool. Dirt and grit blown away by compressed air
can cause serious eye injury.
■
If the supply cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent.
■
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
■
All of the bearings in the product are lubricated with
a sufficient amount of high grade lubricant for the life
span of the product under normal operating conditions.
Therefore, no further lubrication is required.
SYMBOLS
Alternating current
Class II tool, double insulation
Please read the instructions carefully before
starting the product.
Do not dispose of waste electrical and
electronic equipment as unsorted municipal
waste. Waste electrical and electronic
equipment must be collected separately.
Waste light sources have to be removed
from the equipment. Check with your local
authority or retailer for recycling advice
and collection point. According to local
regulations, retailers may have an obligation
to take back waste electrical and electronic
equipment free of charge. Your contribution
to the reuse and recycling of waste electrical
and electronic equipment helps to reduce
the demand of raw materials. Waste
electrical and electronic equipment contain
valuable and recyclable materials, which
can adversely impact the environment and
the human health if not disposed of in an
environmentally compatible manner. Delete
personal data from waste equipment, if any.