AEG AIK3024R Benutzerinformation Seite 65

Problem
There is too much condensed water
inside the fridge.
There are water drops on the glass
shelves.
Water flows inside the fridge.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
Possible cause
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
This is normal that during summer
and autumn more condensation can
form due to the increased air and
food humidity. Fridge does not pro‐
duce any moisture. After this period,
the humidity in the fridge decreases
itself.
There is too much moisture inside
the fridge.
Food prevents the water from flow‐
ing into the water collector.
The water outlet is clogged.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The Frostmatic function or Coolmat‐
ic function is switched on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food is too hot.
Too much food is stored at the
same time.
The thickness of the frost is greater
than 4-5 mm.
The door has been opened often.
The Frostmatic function is switched
on.
The Coolmatic function is switched
on.
There is no cold air circulation in the
appliance.
Solution
Open the door only when necessa‐
ry.
Make sure the door is closed com‐
pletely.
Wrap food in suitable packaging be‐
fore storing it in the appliance.
In summer and autumn, set the
warmer temperature in the refrigera‐
tor (approx. 6-7°C).
Wipe the glass shelves with a cloth
to remove water drops.
Make sure that food does not touch
the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Switch off Frostmatic function or
Coolmatic function manually, or wait
until it deactivates automatically.
Refer to "Frostmatic function" or
"Coolmatic function" section.
Refer to the "Closing the door" sec‐
tion.
Let the food cool down before stor‐
age.
Store less food at the same time.
Defrost the appliance.
Open the door only if necessary.
Refer to the "Frostmatic function"
section.
Refer to the "Coolmatic function"
section.
Ensure cold air circulation in the ap‐
pliance. Refer to the "Hints and tips"
chapter.
ENGLISH 65