Electrical Connection - AEG Electrolux ARCTIS G 7 72 50-8 i Benutzerinformation

Place the small square on the
guide again and fix it with the
screws supplied.
Should the lining up of the fur-
niture door be necessary, use the
clearance of slots.
At the end of operations, it is
necessary to check if the door of
the furniture closes properly.
Fix cover (Hd) on guide (Hb) until
it clips into place.

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup-
ply voltage and current values correspond with those of the mains at the
installation location.
e.g.:
(i.e. 230 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply. The
supply must have a fuse rating of at least 10 Amps.
If the socket is not accessible once the appliance is built in, the electrical
installation must include suitable means of isolating the appliance from the
mains (e.g. fuse, cut-out, current trip or similar with a minimum contact
separation of 3 mm).
Attention: The mains connection cable may only be replaced by a skilled
electrician. Please contact your dealer or our customer service department
for repairs.
34
AC 230 ... 240 V
230 ... 240 V~ 50 Hz
PR168
Hb
Hd
PR167/1
50 Hz or