Herunterladen Inhalt Inhalt Diese Seite drucken

Audible Temperature Alarm; Starting Up And Temperature Regulation - AEG Electrolux ARCTIS G 7 72 50-6 i Gebrauchsanweisung

Integrierbarer gefrierschrank
Inhaltsverzeichnis

Werbung

does not start immediately but only after some time. This does not mean
that your appliance has a fault.

Audible temperature alarm

Your freezer is equipped with an audible temperature alarm, an acoustic
warning sound simultaneously with flashing of the red temperature pilot
lamp, alerting you to the fact that the storage temperature in your freezer
is too high or too warm. The audible warning sounds until is switched on by
operation of the switch (D).

Starting up and temperature regulation

Please clean the appliance interior and all accessories prior to starting the
appliance.
• Plug in the appliance at the mains supply.
• Turn the temperature regulator (B) in the direction of „O"; a sound is on
only for 2 sec.
• The green operating light (A) comes on. The appliance is on.
• The red alarm light (E) flashed and the sound alarm signal.
• Reset the sound alarm signal pushing the switch (D) . The red switch con-
tinuosly flashes.
• Operate the fast-freeze switch (D) once again. The yellow pilot lamp (C)
comes on.
• Only when the red alarm light (E) has gone out should you reset the fast-
freeze switch (D) the yellow light (C) goes out.
Setting "0": Off.
Setting "1": Hightest temperature, (warmest setting).
Setting "4" (end-stop) : Lowest temperature, (coldest setting).
The exact setting should be chosen keeping in mind that the temperature
inside the appliance depends on:
- the quantity of food stored
- how often the door is opened
- ambient temperature
Important:
Regularly check on the red temperature pilot lamp (E) and the thermome-
ter that the required storage temperature is being maintained.
54
Die Abdeckung (Hc) in die Schie-
ne (Ha) eindrücken, bis sie einra-
stet.
Gerätetür und Möbeltür auf ca.
90° öffnen. Den Winkel (Hb) in
der Schiene (Ha) einsetzen. Gerä-
tetür und Möbeltür zusam-
menhalten und die Bohrlöcher
anzeichnen (siehe Abb.).
Die Winkeleisen entfernen
und 8 mm vom äusseren
Rand der Tür mit dem Nagel
(K) kennzeichnen.
Ha
Hc
PR33
8mm
Ha
Hb
PR167
8mm
K
Ha
PR167
11

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis