steute RF Rx SW868 24VAC/DC Montage- Und Anschlussanleitung Seite 8

RF Rx SW868/SW915/SW917/SW922-4W 24VAC/DC
Montage- und Anschlussanleitung / Funk-Empfänger
Mounting and wiring instructions / Wireless receiver
English
Teaching in of transmitters
The output of the receiver can be switched by a maximum of 40 trans-
mitters. To do this, teach in each transmitter once in the receiver.
- Press push-button S1 approx. 1 s
→ LED MD flashes slowly (1 Hz).
- Channel selection: press push-button S2.
- Actuate transmitter to be taught in
→ the LED of the corresponding channel is off for a short time.
- To leave teach-in mode: press push-button S1 approx. 1 s
→ LED MD lights up.
Deleting one transmitter
- Press push-button S1
→ LED MD flashes slowly (2 Hz)
→ Teach-in mode active.
- Release push-button S1
→ LED 1 lights up.
- Press push-button S1 for 5 s
→ LED MD flashes fast, LED 1 lights up.
- Channel selection: press push-button S2.
- Actuate transmitter to be deleted
→ the LED of the corresponding channel is off for a short time.
- To leave delete mode: press push-button S1 approx. 1s
→ LED MD is green.
Inverse teaching in of one transmitter
- Procedure like teach-in but transmitter must be actuated before pro-
cedure is started by pressing S1.
Deleting all transmitters + reset operating mode
- Press push-button S1 for approx. 1 s.
→ LED MD flashes fast
→Teach-in mode active.
- Release push-button S1
→ LED 1 lights up.
- Press push-button S1 for 5 s
→ LED MD flashes fast, LED 1 lights up.
→Delete mode active.
- Release push-button S1.
- Press push-button S1again until LED MD is offand LED 1 flashes.
- Operation mode is set back to standard, the taught in transmitters
have been deleted.
- Release push-button S1
→ receiver restarts.
Maintenance and cleaning
.steute recommends routine maintenance as follows:
1. Remove all dirt particles: Clean enclosure on the outside only.
Clean device in accordance with IP protection class. Clean with
a soft cloth and water or a mild detergent. Do not clean using com-
pressed air.
2. Replace damaged parts.
3. Test the function.
Disposal
- Observe national, local and legal regulations concerning disposal.
- Recycle each material separately.
8 / 16